Hi there this is Amanda coolest from deep trigger, and today I’m going over how to remove the grabber arm from your dg2 worker model, ROV. So simply there’s four pins holding on to the grabber I’m on to the bottom. Here just remove all four like so, and then this is also connected to the back of the RV, so you can follow the line that comes up and enter 0, be using your hands only just twist off just the silver nut make sure you’re not turning the Whole whole tether as you’ll ruin the pin so just twist that off and then pull it straight out and then you will be able to lift your RV off of the grabber. So now that that is gone, take out your deep trekker pouch and find inside your plug, so that no water can get into this this unit here so just plug it in there and then you’re all set for a dive.